Wednesday, 28 September 2016

357 Sig … Update: … Case Resizing Complete

Having loaded 1,000 round on the XL 650, using a Dillon Carbide Die set.

I had 26 loads that failed the “L E Wilson Case Gauge” inspection. All exhibited a slight “case bulge”  near the case base .. often referred to as the “Glock Bulge”.  These 26 cartridges were successfully ran through the Lee Factory 40 S&W die set up for Sizing the 357 Sig cases.

UPDATE:  Now all the loaded ammo passed the case gauge .. on to the range: sig

No comments:

Post a Comment